EN
Performing daily maintenance on your remote-controlled lawn mower not only reduces the incidence of malfunctions but also keeps the equipment in optimal working condition, extending its service life. Daily maintenance should focus on three core dimensions: immediate post-operation upkeep, regular deep maintenance, and protection for special scenarios and long-term storage, ensuring comprehensive and efficient care.
After each operation, first disconnect the power (or turn off the fuel switch), then immediately begin cleaning once the equipment has cooled down. Use a low-pressure setting on a pressure washer or a brush to remove weeds, dirt, and debris from the body, tracks, and wheel crevices to prevent component jamming. Focus on cleaning the blades and blade shafts, wiping away grass residue with a cloth to prevent corrosion from dried sap. If cutting wet grass, thoroughly dry the motor and battery terminals to avoid short circuits. During cleaning, simultaneously inspect blades for nicks or deformation. Minor damage can be repaired by grinding, while severe damage requires immediate replacement to prevent blade breakage during operation and associated safety hazards.
Beyond immediate post-operation maintenance, regular deep maintenance is essential, focusing on core components. For power and transmission systems: - Battery-powered equipment: Weekly checks of battery charge levels and terminals. Clean oxidation from terminals and keep connections dry. Perform a full charge-discharge cycle monthly to prevent battery aging from undercharging. - Gasoline-powered equipment: Change engine oil at intervals specified in the manual. Inspect spark plug carbon buildup every 3 months; clean or replace as needed. Drive belts and gearboxes require bi-monthly inspections. Adjust belt tension promptly if slack is detected. Gearboxes should receive quarterly applications of specialized lubricant to minimize component wear. For mobility and remote control systems: - Tracked equipment: Monthly removal of debris from track treads and tension checks—excessive slack causes slippage, while excessive tightness accelerates wear. - Wheeled equipment: Monitor tire pressure and wear, inflating or replacing tires as needed. Replace remote control batteries weekly. Store spare batteries in a dry location. Clean buttons and signal antennas monthly to ensure responsive command transmission.
For special scenarios and long-term storage, maintenance protocols must be adjusted accordingly. After operating in muddy or dusty environments, disassemble the blade guard immediately to thoroughly clean internal debris. Following rainy season operations, apply rust-preventive spray to metal components like blades and screws to inhibit corrosion. For extended periods of non-use (e.g., winter storage), place equipment in a dry, well-ventilated area. Store batteries separately after fully charging them, and recharge monthly. For fuel-powered equipment, drain fuel tanks completely to prevent fuel degradation and tank corrosion. Before covering with dust covers, apply grease to moving parts like track rollers to prevent component sticking.
